Filter
Top Products
12
Introduction (continued)
Set the video setting switches on the camera unit
before mounting it.
To set the switches, use a fine-tipped
screwdriver.
A [IRIS LEVEL] Iris level adjustment
For adjusting the level of the automatic
aperture control lens. This adjustment only
needs to be made when required. Use this to
accommodate particular shooting conditions.
To darken image: Counterclockwise (L side)
To brighten image: Clockwise (H side)
NOTE:
Prior to adjusting the aperture level, ensure to
set the 1 [AGC] Switch of the function
selection switch G to AOFFB. Otherwise,
when the level is turned too far toward L, the
AGC function activates increasing sensitivity
and the picture may look uneven.
B [ZOOM/FOCUS, MEMORY] zoom, focus
adjustment switches/position memory
button
Use the [JTELE] and [KWIDE] switches to
zoom, and the [HFAR] and [INEAR] switches
to adjust focus. (A pg. 25)
Press the [MEMORY] button to register the
position. (A pg. 25)
C [ALARM POSITION] status indication LED
Light off : Registration of home
position is enabled
Light on (red) : Lens initializing.
Light on (green): Registration of alarm
position is enabled
Blinking (green): Position memory
registration mode N
memory registration
completed
(A pg. 25)
D [POSITION SELECT] POSITION SELECT
button
Press this button to switch between the home
and alarm positions. Display on the status
indication LED C will change accordingly.
(A pg. 25)
E [RESET/SPOT] RESET/SPOT button
When this button is pressed, the value of the
white balance or phase adjusted manually is
reset to the default value.
●When the 2 [SELECT] switch is set to
[WHT.BAL.], the white balance is reset to the
default value.
When the switch is set to PHASE, the phase
is reset to the default value.
●When setting to SPOT:
When this button is pressed, white-spots are
corrected.
For instructions on correcting white-spots, see
AWhite-spot correctionB (A pg. 27).
F [R/B, +/-] R/B, +/- adjustment button
This button is pressed when manually
adjusting the white balance or when adjusting
the vertical phase of the line lock.
The function of this button is selected using
the 2 [SELECT] switch.
●When manually adjusting the white balance:
Press the R button to increase the red tint and
decrease the blue tint.
Press the B button to increase the blue tint
and decrease the red tint.
●When adjusting the phase:
Press the + or - button to adjust the phase.
G Function selection switches
1. [AGC] Auto-gain control switch.
Setting this switch to AONB automatically
increases the sensitivity even when the
brightness of the subject is insufficient.
(Default setting: ON)
Setting the Lens and
Switches (TK-C215V12)
B
RESET/[SPOT]
LL PHASE
R
WHT.BAL.
H
L
IRIS
LEVEL
ZOOM/FOCUS
FAR
WIDE
NEAR
POSITION
SELECT
POSITION
ALARM
[MEMORY]
2
4
1
2
3
4
5
6
7
8
TELE
A
G
B
C
D
E
F
WHT.BAL.
PHASE
RESET/SPOT
8
TRIGGER
STATE
ALARM
7
OFF
ON
DAY/NIGHT
6
5
OFFBLC
ON
4
ON
ON
AGC OFF
OFF
MANUAL
3
ATW
2
LLSYNC
INT
1
WHT.BAL.
SELECT
RESET
SPOT
Function selection switch setting table
(Items in bold are factory position)
TK-S215_EN.book Page 12 Tuesday, March 28, 2006 9:39 AM