Filter
Top Products
26
Adjusting Image (continued)
Registering alarm position
For registering the angle of view during
monitoring when there is an alarm input.
1. Check that the [ALARM POSITION]
indicator light is turned on.
Registration of alarm position is enabled.
●Press the [POSITION SELECT] button if the
[ALARM POSITION] indicator light is off.
2.
Adjust the image size. (
A
pg. 25)
3.
Press the [MEMORY] button for 2 seconds
or longer.
The [ALARM POSITION] indicator light blinks
for 3 times (green)
ALARM position registration is completed
4.
Adjust the brightness. (
A
pg. 25)
5.
Press the [POSITION SELECT] button.
The camera returns to the home position
NOTE:
●Be sure to return the camera to the home
position after registration of the alarm position
is completed.
In addition to pressing the [POSITION
SELECT] button, you can also use the power
ON/OFF button to return the camera to the
home position.
●To check images at the registered home
position or alarm position, press the
[POSITION SELECT] button. Press this
button to switch between the image at the
home and alarm positions.
After setting is complete, mount the dome cover.
1. Mount the dome cover.
Align the position marks on the camera unit
and dome cover, followed by pressing in
directly to mount the cover.
CAUTION:
Press the dome over until a “click” sound is
heard. Check that the cover is firmly mounted.
Failure to mount the cover firmly may cause
this cover to fall off.
Adjusting Images
(continued)
Ň
B
RESET/[SPOT]
LLPHASE
R
WHT.BAL.
H
L
IRIS
LEVEL
ZOOM/FOCUS
FAR
WIDE
NEAR
POSITION
SELECT
POSITION
ALARM
[MEMORY]
2
4
1
2
3
4
5
6
7
8
TELE
4.
1.,5.
2.,3.
Mounting the Dome Cover
1.
Position mark
TK-S215_EN.book Page 26 Tuesday, March 28, 2006 9:39 AM