Filter
Top Products
27
As a general characteristic unique to CCDs,
white-spots may appear on the screen with age.
In order to reduce this phenomenon, this unit is
equipped with a white-spot correction feature.
Switch on the camera power supply and wait for
at least 30 minutes.
(Not available on TK-C210FW)
TK-C215V4
TK-C215V12
1. Remove the dome cover.
2.
Cover the lens surface using a black sheet
of paper, etc. so that light does not enter
the lens.
3.
Set the function selection switch 8 to
[SPOT]. (
A
pg. 11, 13)
4.
Press and hold the SPOT CORRECTION
button for more than 2 seconds.
●White-spot correction will start. Correction
may take several seconds for completion.
NOTE:
● Maximum correction: 32
● The white-spot correction feature of this
unit does not guarantee the correction of
all white spots.
Depending on the characteristic of white
spots, correction may not be possible.
● When performing white-spot correction,
accurate data may not be achieved in case
of highly detailed pixels since correction is
made using the information of surrounding
pixels.
● The result of white-spot correction is
maintained until the next correction is
performed.
White-spot correction
RESET/
[
SPOT
]
LL PHASE
1
O
N
2
3
4
5
6
7
2
4
WHT.
BAL.
8
B
R
Function selection switch 8
[SPOT] button
B
RESET/[SPOT]
LLPHASE
R
WHT.BAL.
H
L
IRIS
LEVEL
ZOOM/FOCUS
FAR
WIDE
NEAR
POSITION
SELECT
POSITION
ALARM
[MEMORY]
2
4
1
2
3
4
5
6
7
8
TELE
Function selection
switch 8
[SPOT] button
TK-S215_EN.book Page 27 Tuesday, March 28, 2006 9:39 AM