Filter
Top Products
13
3. [SYNC] Synchronization system selection
switch.
This switch sets the synchronizing system for
the camera.
INT:
This is set for internal synchronization
LL (Line Lock):
The camera’s vertical synchronization is
locked to the AC 24 V 60 Hz or 50 Hz power
line frequency. When switching between
multiple cameras using a switcher, selecting
this mode and adjusting the vertical phase
can reduce the monitor sync disturbances
occur that when the camera image is
switched.
U type: 60 Hz only
E type: 50 Hz only
(Default setting: INT)
4. [WHT.BAL.] ATW/MANUAL selection
switch.
For selecting whether to adjust the white
balance automatically or manually.
When the setting is changed from manual to
ATW, the setting values in the manual mode
will be reset. The camera switches to the
same mode as with pressing the [RESET]
button.
(Default setting: ATW)
Memo:
● The white balance of this camera is preset
to use under sunlight or halogen lamps,
and may not be properly adjusted when
used under artificial lights such as
fluorescent lights.
5. [BLC] Backlight compensation switch.
When the object is placed against the light,
setting this to AONB increases the iris
aperture by 1 stop and the object will appear
clearer.
(Default setting: OFF)
6. [DAY/NIGHT] Easy Day & Night switch.
To capture a subject with continually
changing brightness (day/night), set this
switch to AONB.
The camera automatically captures the
image in color when the subject is bright, and
in black and white mode when it is dark.
(Default setting: OFF)
Memo:
● When this item is set to AONB, the AGC
feature will automatically be set to AONB
regardless of the [AGC] Switch 1 setting.
● The Easy DAY & NIGHT feature on this
camera uses a sensitized black and white
mode unlike other black and white
surveillance cameras that use infra-red
lighting.
● Sensitivity increases in the case of black-
and-white images. The screen may
therefore appear rougher and white spots
may increase.
7. [RESERVED]
Not used. Ensure to set this to AOFFB before
using the camera.
(Default setting: OFF)
8. [RESET/SPOT] RESET/SPOT
CORRECTION selection switch.
RESET:
The [RESET/SPOT] button is used as a
[RESET] button.
SPOT:
The [RESET/SPOT] button is used as a
[SPOT] button. (A Pg. 28)
(Default setting: RESET)
D [IRIS LEVEL] Iris level adjustment
For adjusting the level of the automatic
aperture control lens. This adjustment only
needs to be made when required. Use this to
accommodate particular shooting conditions.
To darken image: Counterclockwise (L side)
To brighten image: Clockwise (H side)
Memo:
● Prior to adjusting the aperture level,
ensure to set the [AGC] Switch 1 of the
function selection switch C to AOFFB.
Otherwise, when the level is turned too far
toward L, the AGC function activates
increasing sensitivity and the picture may
look uneven.
E [FOCUS ADJUST] focus adjustment
button
Use this to adjust the lens focus.
Upon pressing, the lens aperture will open up
for about 30 seconds such that the depth of
field becomes shallower, thus enabling focus
to be easily adjusted. (A Pg. 23)
Memo:
● The electronic shutter functions
automatically upon pressing the focus
adjustment button and the screen may
flicker. However, this is not a malfunction.
F Focus adjustment ring
Move this to the left/right to adjust the focus.
G Zoom adjustment ring
Move this to the left/right to adjust the field
angle.
TK-C215VP4_JP.book Page 13 Wednesday, September 20, 2006 5:48 PM