Filter
Top Products
17
Remove the dome cover, followed by setting the
video image switches.
1.Removing the dome cover
Remove the dome cover by unfastening the 3
fastening screws using the wrench supplied.
Memo:
● The dome cover and base are connected
with fall prevention wire.
2.Removing the inner dome
The inner dome is fastened using lugs at 3
different positions. Grasp the inner dome and
remove it from the lugs.
Note:
● Before touching the camera unit, make sure
to touch the metal surface of the [MONITOR]
terminal to discharge any static electricity
from your body. Static electricity may cause
the camera to malfunction.
3.Setting the switches
Set the switches for video images.
(A Pg. 12)
Remove the camera unit from the base and
mount the base to the ceiling or wall.
When mounting to a wall, follow the procedures by
replacing areas indicated as [ceiling] by [wall] accordingly.
1.Removing the camera unit from the base
A Unfasten the 2 fastening screws from the
camera unit using a screwdriver.
B Press the 2 lugs inwards to remove the
camera unit from the base.
Setting the switches
Wrench (Supplied)
Fall Prevention
Wire
2
3
LL PHASE
1
2
O
N
3
4
5
6
7
2
4
WHT.
BAL.
8
Inner
Dome
Lug(x 3)
Mounting the base
Setup
Drill mounting holes (R30 mm, 1 1/8 inch)
using the template supplied when necessary.
Coaxial Cable
Approx. 100 mm
(37/8 inch)
R30 mm
(1 1/8 inch)
Power Supply Wire
(AC 24 V only when heater is in use)
A
B
Camera
Base
Lug(x 2)
TK-C215VP4_JP.book Page 17 Wednesday, September 20, 2006 5:48 PM