Filter
Top Products
27
Mounting the camera using the piping
hole at the side surface of the base
If the camera cannot be mounted directly to the
ceiling, mount it to the pipe using the piping hole
at the side surface of the base.
1.Setting the switches (A Pg. 17)
2.Dismantle the camera unit from the base
and mount the fall prevention wire
(A Pg. 17)(A Pg. 18)
3.Binding the sealing tape
Bind at least 2 layers of the sealing tape to the
joint of the pipe (point where the thread of the
piping hole coincides with the screw hole of the
pipe).
4.Removing the plug for the piping hole of
the base
Loosen the mounting screw (M3 x 6 mm) using a
slotted screwdriver and pull out the plug at the
side of the base.
5.Mounting the removed plug for the piping
hole to the piping hole at the bottom surface
of the base
6.Mounting the base to the pipe
Screw the pipe into the piping hole at the side of
the base.
(Piping hole: G3/4-14 UNC)
Note:
● When screwing in the pipe, make sure that
not more than 12 mm (15/32 inch) of the pipe
is being screwed in. Failure to do so may
damage the internal components of this unit.
7.The following procedures are same as
normal mounting
●Cable Connection (A Pg. 19)
●Mounting the camera unit to the base
(A Pg. 20)
●Adjusting Images (A Pg. 22)
●Mounting the inner dome (A Pg. 24)
●Mounting the dome cover (A Pg. 24)
Sealing Tape
Plug for Piping Hole
Mounting
Screw
Plug for Piping
Hole
TK-C215VP4_JP.book Page 27 Wednesday, September 20, 2006 5:48 PM