Filter
Top Products
28
Setup
Adjusting the camera shooting direction
This camera can be adjusted for pan, tilt and
rotation. Adjust the direction and face the
camera towards the object.
Note：
● Make sure you touch the metal surface of the
[MONITOR] terminal to release the static
electricity in your body before adjusting the
camera shooting direction.
● Make sure that the pan fastening screw is
loosened before adjusting the camera
shooting direction. The lens section may be
damaged if you operate it without loosening
the pan fastening screw.
Memo：
● Rotate both pan and rotation ±175 Њ from the
positions aligned with the camera imaging
direction mark, pan center mark and rotation
center mark. Make sure you hold the rotation
claps and adjust the rotation without holding
the lens section.
● After adjusting the field angle, tighten and
secure the tilt fastening screw and pan
fastening screw so that the field angle will not
be misaligned when using the camera in
locations with vigorous vibrations. (A Pg. 12)
Note：
● Moving the camera when it has exceeded the
adjustment range may cause its performance
to deteriorate.
● As the tilt and rotation range of this camera is
wide, part of the camera may be reflected in
the shooting screen depending on the field
angle and direction.
● Do not hold the lens section when adjusting
the camera direction. The lens section may
be damaged if you apply force to it.
Adjusting field angle, focus and
brightness
Once you have decided the shooting direction,
you can adjust the field angle, focus and
brightness.
Image adjustment
(continued)
Tilt: ±80 Њ
Pan: ±175 Њ
Rotation: ±175 Њ
H
I
RIS
E
VEL
S
ADJ
C
E
S
ADJ
SPOT
Pan center mark
Imaging Direction
mark
Rotation center
mark
Pan fastening screw
:Be sure to loosen it
before adjustment.
Rotation Knob
:Make sure you hold
and turn this knob when
adjusting the rotation.
N F
W T
LH
FOCUS ADJUST
IRIS
LEVEL
Iris level
adjustment dial
Focus adjustment
button
Zoom adjustment ring
Focus adjustment ring
VN-C215_EN.book Page 28 Monday, November 27, 2006 9:46 AM