Filter
Top Products
5
2. Connecting to a network
Turn on the power of only one VN-C2U.
Connecting VN-C2U to a network and turning on the power will connect the unit to a network with the
following IP address.
Note
Factory set IP address : 192.168. 1. 2
All VN-C2U at the time of shipment have the same IP address. Correct
access cannot be obtained when turning the power of multiple units on at the
same time due to overlap of ID addresses. Always turn on the power of one
unit at a time and proceed with the following VN-C2U IP address setup.
In the case where doubling of IP addresses occur, correct access may not be
achieved unless waiting for at least 10 minutes after making correction, or
turning off all network devices then turning them back on.
To power outlet
When connecting to a HUB, use a straight cable.
When connecting directly to a PC, use a crossing cable.
Special adapter
Shielded
modular cable
To retain electromagnetic compatibillity,use the provided
ferrite core when connecting to VN-C2U.
Install the ferrite core within 50mm
of VN-C2U-side connector.
Ferrite core
Wound 3x