Filter
Top Products
10
Notes
The V.NETWORKS setup tool will only operate on PCs installed using the
procedure described on page 7 (execution of setup.exe). The setup tool will
not operate properly if setup.exe has not been executed. For PCs that have
executed setup.exe can also operate the setup tool by copying the setup
folder to the hard disk, etc. The V.NETWORKS setup tool is a software that is
used only when setting up. In case the folder is copied, we asked that it be
deleted after completion of the setup, unless the PC requires the folder for a
special reason.
For setup of a second unit and following, reboot the PC and return to step 2
(page 5). Proceed when all VN-C2U settings are completed.
3-4 Restoring the IP address of the work PC
In the same manner as 3-1, start from the [Start] button then go [Setup]-[Control Panel]-
[Network], then correct/restore the TCP/IP properties of the network settings to the original IP
address which was noted.
After correction, reboot the PC according to the on-screen instructions.
4. Enabling the set IP address
Turn the power of VN-C2U off, then turn the power back on.
(The pan/tilt mechanisms will reset when the power is turned on. This reset operation can be used
to check that the unit is operating normally.)
The IP address changed using the setup tool is enabled for the first time when the power of VN-
C2U is turned off, then turned backed on.
(The unit will continue operation using the IP address before the change until the power is turned
off.)
[ IP ADDRESS SEARCH FUNCTION]
By pressing the "Search" button, you can view the IP address of V.NETWORKS now connected to
the network.Pressing the search button brings up the [search screen] window.
By pressing "Search" on the [search screen] window, a list
of IP address of all V.NETWORKS is displayed. Using TIME-OUT,
you can set the time for search from 0 to 30 seconds.