Filter
Top Products
KODAK 305 Photo Printer
14
Notes
1) Secure of Hard disk for spool fi le
Secure the capacity of Hard disk for spool file enough for the printer operation and the number of
printing sheets.
The printing cannot be correctly carried out when the capacity is running short.
The drive for spool fi le is the same drive as the drive of Windows system usually.
2) Operation of the printer
Refer to the operation manual of the printer.
Do not turn off the power switch during data transfer or print.
If you turn off the power switch, restarting of a computer may be needed.
(When deletion of a printing data cannot be performed, restarting of a computer is required.)
3) Applicability of color adjustment
The color adjustment is applied to the entire printing range including the background.
4) About “Print directly to the printer”
With some applications, if “Print directly to the printer” is selected, objects may not be printed correctly.
In that case, select “Spool print documents ...” by the “details” page of printer property sheet.
5) About connection of a computer and a printer
Do not disconnect the interface cable during data transfer.
If a USB cable is disconnected, wait 1 minute or more after disconnecting the cable to connect it again.
If the cable is connected without leaving an enough interval, the printer driver may not work correctly.
6) System requirements for USB interface
Use a personal computer with Windows XP, Windows Vista, or Windows 7 pre-installed, and make sure
that its USB operation is guaranteed by the manufacturer.
The KODAK 305 Photo Printer supports USB 2.0 (Hi-Speed USB) interface. As USB 2.0 is fully upward-
compatible with USB 1.1, the KODAK 305 Photo Printer can be used with a personal computer that
supports USB 1.1 interface.
To use the KODAK 305 Photo Printer based on USB 2.0 (Hi-Speed USB), connect with a personal
computer that supports USB 2.0 (Hi-Speed USB). For USB 2.0 (Hi-Speed USB) compatibility of your
personal computer, contact the manufacturer of the personal computer.
7) Connection of USB cable
When you take out and insert a USB cable after installation of a printer driver, wait 10 seconds or more
after extracting a cable.
If the cable is reinserted without leaving an interval, the printer may not operate normally.
8) Print job
Do not delete the print job in the spooler during data transfer. When deleting it, do not start printing until
the printer becomes to the initial status.
9) Number of prints
With some applications, the number of prints set by the printer driver does not work. Set the number of
prints from the print dialog box of the application.
10)Remainings
Remainings on the Paper tab shows the remainings of the ribbon by a bar, by reading information from
the printer when the Paper tab is displayed. The correct information may not be acquired during printing.
11)Connection with more than one printer
When multiple KODAK 305 Photo Printers are connected to one personal computer, the “Add New
Hardware Wizard” will be displayed and installation of the printer drivers will be carried out repeatedly
for each connected printers. The same number of printer drivers as that of connected printers are
installed.