Filter
Top Products
KODAK 305 Photo Printer
16
Prohibition matter
We prohibit Reverse Engineering, decompiling or reverse assembling of this driver software.
Exemption from responsibility
Occasionally, this software does not operate normally depending on operating environment.
Moreover, Eastman Kodak Company will not assume any responsibility for damage (including, but not lim-
ited to, lost profi t or damage caused from special circumstances etc.) occurring during the use of this driver.
2. Making the ICC profi le
Refer to the following when you make a suitable ICC profi le for the system to be used and apply it to the
printer driver.
1) Set the printer driver as follows when you print the basic color chart for making ICC profi le using the
printer.
Delete the ICC profi le, if any, set on the “Color control” tab of the printer property.
Set the “Color matching” on the option tab of the printer driver to OFF.
Set the “Color conversion” on the option tab of the printer driver to “none”.
2) Add the new ICC profi le using the “Color control” tab of the printer property.
3. To adjust the gray balance in the low gray levels, use “Color correction” on the option tab.
To weaken the Yellow tone :Increase the “B” value.
To weaken the Magenta tone :Increase the “G” value.
To weaken the Cyan tone :Increase the “R” value.
To weaken the Red tone :Decrease the “R” value.
To weaken the Green tone :Decrease the “G” value.
To weaken the Blue tone :Decrease the “B” value.