Filter
Top Products
21
Installing the (supplied) Battery Pack
- Before installing or changing battery packs, make sure the power is OFF
(p.28), check that the LCD monitor is not lit and turn OFF all switches.
Preparing the Power Supply (Cont’d)
1. Open the battery/card cover by sliding
it in the direction of the arrow.
Do not change the battery with wet
hands, as there is a danger of electric
shock.
2. Install the battery with the terminals
facing inside the camera. After making
sure the battery pack is properly
installed, close the battery/card cover
securely.
Make sure that the battery pack is facing
the right way. If the battery pack is installed
incorrectly, there is a danger of injury or
contamination, or the camera may be
damaged due to leakage and/or heat.
●Battery level indicator
As the battery runs out of power, the battery level indicator displays the
power remaining as follows:
(Remaining power is shown on the LCD monitor in two levels)
1.
Fully charged
2.
Power is running out; change (charge) the battery.
1
2