Filter
Top Products
93
CONNECTING THE CAMERA TO A COMPUTER
Start up the computer. The computer must be turned on before connecting the camera.
Insert the CompactFlash card into the camera. Confirm that the
correct card is in the camera. To change the CompactFlash
while the camera is connected to a computer, see page 102.
A fresh set of batteries should be used when the camera is connected to a computer. The use of the
AC adapter (sold separately) is recommended over the use of batteries. For users with Windows 98
or 98SE, read the section on how to install the necessary USB driver before connecting the camera
to a computer (P. 95).
1
2
3
Open the card-slot door. Attach the smaller plug of the USB
cable to the camera. Make sure the plug is firmly attached.
Attach the other end of the USB cable to the computer’s USB
port. Make sure the plug is firmly attached.The camera
should be connected directly to the computer’s USB port.
Attaching the camera to a USB hub may prevent it from
operating properly.
4
4
3
5
Trans
Initializing USB
connection
Set the mode dial to the data-transfer position to initiate the
USB connection. A screen will appear to indicate the beginning
of the connection process. When the signal has been received
by the computer, the LCD monitor will turn off.