Filter
Top Products
CREATIVE
EXPOSURE
Control dial
Canceling the Flash
6362
Press the flash-mode button
to pop-up the built-in
flash.
• will appear on the data panel.
In M mode, the flash will not fire automatically. When you want to use the
flash, pop-up the built-in flash or attach an accessory flash.
• The camera’s automatic flash metering system will ensure proper
exposure.
Push the built-in flash down or turn the accessory flash off.
• will be displayed on the data panel.
To select the shutter speed,
turn the control dial.
• The maximum shutter speed is 1/90 sec
when using flash.
The shutter speeds
slower than 1/90 can be used
To select the aperture, press
the exposure-compensation
button while turning the
control dial .
• Refer to the flash range on page 36 to
determine the aperture setting.
Flash with M mode
1
2
M-MODE – MANUAL
Exposure-
compensation
button
3
Set the camera to custom 8-2.
See page 105 for instructions.
Press the shutter-release
button partway down to display
the shutter speed and aperture
value. Turn the control dial to
change the aperture.
• The shutter speed is automatically
adjusted to ensure correct exposure.
While pressing the function
button, turn the control dial
until P appears on the data
panel.
Select P mode when you want to give your full attention to your subject and
composition by letting the camera control both the shutter speeds and aper-
ture. The P mode software analyzes the subject’s size, motion, and distance
as well as the focal length of the lens, then controls the shutter speed and
aperture to correctly expose the scene.
Turn the function dial to .
P MODE
2
PA
Mode
The aperture can be changed in P mode with the Custom 8 -2
setting.(p.109).
1
2
1
Continued on next page