Filter
Top Products
4-23
4
Using C Camera Mode, N Continuous Shooting Mode and M Movie Mode
• Because this setting is retained even when the camera is switched off, you need to restore
the original setting or otherwise modify the setting to suit the scene or subject being shot.
• When using the flash for close-up shots, you should set the ISO sensitivity to 200 or less.
If you set the sensitivity to a high ISO setting and then take close-up shots, the image will
be overexposed. The flash brightness cannot be adjusted correctly at ISO 800.
Applicable mode: C/N
This setting allows you to select the area that the camera uses when setting the exposure.
The available settings are [EVALUATION], [CENTER] and [SPOT AREA]. Use the setting
that best suits your subject.
4
Press
U
or
D
on the 4-way button to select
[ISO] and then press
R
.
5
Press
U
or
D
on the 4-way button to select
the desired ISO setting and then press the
OK button
E
.
[No icon] AUTO: The camera sets the ISO sensitivity to suit
the ambient conditions. (default)
[ISO100] 100: Fixed at ISO 100
[ISO200] 200: Fixed at ISO 200
[ISO400] 400: Fixed at ISO 400
[ISO800] 800: Fixed at ISO 800
6
Press the MENU button K to clear the menu.
7
The selected setting ([ISO200], etc.) appears
on the LCD monitor.
[METERING]
Selecting the Area Used for Setting the Exposure
1
Switch the camera on and press
O
or
Q
on the mode
button until the “
C
” or “
N
” icon lights on the mode select
LED.
2
Press the MENU button K to display the menu icons.