Filter
Top Products
15
Lens Installation / Removal
To Install Lens
1. Perform O-ring inspection.
2. Align lens to housing details.
3. Press lens into housing.
4. Rotate clockwise until Locking pin engages.
To Remove Lens
1. Slide Locking pin outward away from lens.
2. Rotate lens counter clockwise.
3. Pull away from housing.
Reversing Smart Grip Button Functions
Smart Grips can be programmed to swap left and right button functions. This is useful if a
Smart Grip battery becomes exhausted during a dive. You then can swap Smart Grip functions
to maintain primary housing operation.
This is a total button function swap, not a button-by-button nor a custom configuration.
Press either FAR/- and NEAR/+ or TELE and WIDE buttons simultaneously and hold for
three seconds. Button functions are now swapped. Button functions will mirror opposite
handle, i.e. REC and PHOTO, AF/OFF and PHOTO DIS.
This is a handle-by-handle procedure. Performing this function on one handle will not switch
both of the handles at once.
Revert to original button configuration
Perform the same swap procedure. Press either FAR/- and NEAR/+ or TELE and WIDE
simultaneously and hold for three seconds.
Eventually the batteries in the Smart Grips will totally exhaust. Contact Light & Motion to
order a replacement battery and O-ring kit (part #802-0117), or remove the Smart Grip handle
cover and replace the two batteries located inside. Batteries are CR 1/3 N and can usually be
purchased from any store that stocks camera and watch batteries.