Filter
Top Products
(Fig. 28) (Fig. 29)
Housing Storage
Store housing and Travel Case in a dry location the first 24 hours after a dive. Leave the Rear
Plate off the housing to allow for air circulation. Similarly, leave Travel Case Lid about two
inches open. Allow any residual water to evaporate from the Travel Case prior to storing the
housing.
Replacing Handle Batteries
1. Using an Allen key, remove the two screws on the back of the handle. (Refer fig. 28)
2. Remove the Handle Cap from the handle assembly (Refer fig. 29).
3. Remove old batteries from handle board.
4. Install new 1/3 N batteries into the handle board (Refer. fig. 30).
Note: The +/- position of the batteries is critical. If batteries
are installed backwards, they will damage the handle board.
5. Inspect the Handle Cap O-ring or replace with a new O-ring.
6. Press the Handle Cap into the handle assembly so O-ring seals evenly.
7. Replace both screws in Handle Cap and tighten using Allen key.
Smart Grip O-ring and Battery Kit—Part # 802-0117 (Refer fig. 31)
Kit contains one O-ring and battery set for one Smart Grip.
25