Filter
Top Products
19
Charging the Remote and Compact Monitor
1. Remove the Charging Port Plug using a coin or large flat head screwdriver
(Refer Fig. 23).
2. Plug charger into a 110v outlet.
This charger is only rated at this voltage. If you do not have
access to a 110v outlet, you must use a converter.
3. Plug charging connector from charger into charging port on Remote Monitor.
4. Charge for 8-14 hours, then remove charging cord.
5. Check O-ring on Charging Port Plug.
6. Replace Charging Port Plug.
IMPORTANT: Failure to re-install Charging Port Plug WILL flood the Monitor.
Diving Without a Monitor Attached
If you do not use the monitor you MUST de-activate power to the bulkhead before entering
the water.
To de-activate BlueFin bulkhead:
1. Remove the Rear Plate.
2. Locate the power switch on the inside of the Rear Plate.
3. Move the switch to the OFF position.
(Fig. 23) (Fig. 24)
Charging Plug