Filter
Top Products
DEFINITY® Enterprise Communications Server Release 7
Console Operations Quick Reference
555-230-890
Issue 3
June 1999
Console Operations
12Basic Operation
To make calls not using the selector console, perform the following:
1. Press the
START button or an idle call appearance button.
■ You hear a dial tone.
■ The call appearance lamp goes on.
■ The Position Available lamp goes off.
2. Dial the extension.
■ You hear a ringback tone.
■ The display shows the dialed number.
■ The ringback tone stops when the called party answers.
3. To end the call, press the
RELEASE button.
■ You are disconnected from the call.
■ The call appearance lamp goes off.
■ The display goes blank.
■ The Position Available lamp goes on.
■ The console returns to the normal operating mode.
NOTE:
Before the call completes, you can press the CANCEL or RELEASE
button to end the call attempt. If you press
CANCEL, you get another
dial tone. If you press
RELEASE, the console returns to the normal
operating mode.
Making a call to an outside number requires an outgoing trunk. You can access an
outgoing trunk in two ways:
■ You can make a call to an outside number by dialing a code for the
Automatic Route Selection feature or a specific trunk group, or
■ You can make a call to an outside number by pressing the trunk group
select button for the desired trunk.
NOTE:
Trunk group select buttons are not available at some locations. If the
trunk group select buttons are not administered, dial the trunk access
codes using the dial keypad.
230890_3.bk Page 12 Tuesday, April 20, 1999 12:57 PM