Filter
Top Products
The Roll Film Holder
Attaching the Holder
1. Slide the Holder Lock Lever of the Roll
Film Holder completely toward the Lock
Release Lever “A”.
2. Align the orange circle “B” of the Revolving
Ring (found at the rear of the camera) with one
of the two white index marks “C” or “D”
on the
camera body.
3. Hold the Holder so that its orange circle is at
the same position as the one on the Re-volving
Ring “B” and fit the holder onto the camera
back, making sure that the four Camera Back
Mount Pins fit into the four openings of the
holder.
• Do not touch the Light Baffle or mirror.
Touching the Baffle could result in light leaking
in or other malfunction.
4. Lock the holder to the camera body by
moving the Slide Lock as far as it will go as
indicated by the arrow.
• Make sure that the holder securely couples
with the camera body; otherwise light may
leak in and cause film damage.
Because of the revolving back feature,
attaching the roll film holder to the camera
requires a little practice. We find that a good
method is to place the bottom edge of the
holder against the bottom edge of the body,
(preferably while resting on a flat surface)
letting the top of the holder leave a slight
gap, permitting you look down and to match
the two bottom mounting pins of the
revolving back to the corresponding holes of
the holder.
22