Filter
Top Products
gently wind the Film Advance Knob until the
arrow of the backing paper aligns with the
insert Start Mark.
As your gently advance the backing paper,
make sure it advances evenly between the
spool flanges and does not begin to slant. If
it advances unevenly, remove the backing
paper from the Take-up Spool and re-insert.
Heeding this point will eliminate the
possibility of crimping the edge of the film.
Set the correct film speed value on the
Film Speed Dial of the Roll Film Holder.
Place the Film Insert into the housing,
making sure the film advance coupler of the
insert fits into the appropriate hole of the
cassette.
25
After correctly placing the insert into the
housing, close the back cover, and while
gently holding it in place, push both of the
Back Cover Latches as far as they will go.
The Roll Film Holder Housing will accept ei-
ther 120 (HA703) or 220 (HB702) Film
Inserts.