Moxa Technologies 351 Security Camera User Manual


 
- 12 -
Wall Mounting (Optional)
Follow the steps below to mount the VPort 351 on a wall or panel.
STEP 1:
Remove the aluminum DIN-Rail attachment plate from VPort 351, and then
attach the wall mount plates, as shown in the diagrams below.
Top
plate
Bottom
plate
STEP 2:
Mounting the VPort 351 on the wall requires 4 screws. Use
the VPort 351, with wall mount plates attached, as a guide to
mark the correct locations of the 4 screws. The heads of the
screws should be less than 6.0 mm in diameter, and the
shafts should be less than 3.5 mm in diameter, as shown in
the figure at the right.
Do not screw the screws in all the way—leave a space of
about 2 mm to allow room for sliding the wall mount panel
between the wall and the screws.
6.0 mm
3.5 mm
NOTE
Test the screw head and shank size by inserting the screw into one
of the keyhole shaped apertures of the Wall Mounting Plates,
before it is screwed into the wall.
STEP 3:
Once the screws are fixed in the wall, insert the
four screw heads through the large parts of the
keyhole-shaped apertures, and then slide VPort
351 downwards, as indicated in the figure.
Tighten the four screws for added stability.
2
1
2
1
Wiring Requirements
ATTENTION
Safety First!
Be sure to disconnect the power cord before installing and/or
wiring your Moxa VPort 351.
Calculate the maximum possible current in each power wire and
common wire. Observe all electrical codes dictating the
maximum current allowable for each wire size.
If the current goes above the maximum ratings, the wiring could
overheat, causing serious damage to your equipment.
Manual
Amplicon.co.uk IT and Instrumentation for industry
Sales: +44 (0) 1273 570 220 Website: www.amplicon.co.uk Email: sales@amplicon.co.uk