Filter
Top Products
- 20 -
LED Indicators
STAT Indicates if the system booted properly
PWR1 Power 1
PWR2 Power 2
FAULT Can be configured to correspond to system alarm,
power failure, video loss, or disconnected network
VIDEO Video input signal active
AUDIO TEST Audio input signal in test mode
PTZ PTZ control signal active
Power
Input Two 12/ 24 VDC or 24 VAC for redundancy
Consumption Near 8W
Mechanical
Casing IP30 protection, metal case
Dimension (W x D x H) 52.98 x 135 x 105 mm (2.09 x 5.31 x 4.13 in)
Weight 960 g
Installation DIN-Rail or wall mounting
Environmental
Operating Temperature 0 to 60°C (32 to 140°F)
-40 to 75°C (-40 to 167°C) for –T models
Storage Temperature -40 to 85°C (-40 to 185°F)
Ambient Relative Humidity 5 to 95% (non-condensing)
Regulatory Approvals
Safety UL 508
Hazardous Location UL/cUL Class I, Division 2, Groups A, B, C and
D (Pending), ATEX Class I, Zone 2, EEx nC IIC
(Pending)
EMI FCC Part 15, CISPR (EN55022) class A
EMS EN61000-4-2 (ESD), Level 2
EN61000-4-3 (RS), Level 3
EN61000-4-4 (EFT), Level 3
EN61000-4-5 (Surge), Level 3
EN61000-4-6 (CS), Level 3
EN61000-4-12
(Oscillatory wave immunity), Level 3
Shock IEC60068-2-27
Freefall IEC60068-2-32
Vibration IEC60068-2-6
MTBF 160,000 hours
Warranty
5 years
Alarm Features
y Pre/Post alarm video recording (9 MB memory)
y Video motion detection with sensitivity tuning
y Daily repeat timing schedule
y JPEG snapshots for pre/trigger/post alarm images
y Automatic transfer of stored images by email or FTP with event-triggered
actions
y HTTP Action setting for customized alarm messages being sent via HTTP
Event Server
PAN/TILT/ZOOM
y PTZ camera control through RS-232/422/485
y Supported devices and protocols:
Dynacolor DynaDome, Pelco D-protocol, Pelco P, Custom Camera
y PTZ driver upload
y Transparent PTZ Control for controlling the PTZ camera with legacy PTZ
control panel or keyboard
Manual
Amplicon.co.uk IT and Instrumentation for industry
Sales: +44 (0) 1273 570 220 Website: www.amplicon.co.uk Email: sales@amplicon.co.uk