Filter
Top Products
BP-25H CE GASOLINE VIBRATOR — OPERATION MANUAL— REV. #4 (12/19/07) — PAGE 23
BP-25H CE GASOLINE VIBRATOR — MAINTENANCE (ENGINE)
Daily
■
Thoroughly remove dirt and oil from the engine and
control area. Clean or replace the air cleaner elements
as necessary. Check and retighten all fasteners as
necessary. Check the gearbox for oil leaks. Repair or
replace as needed.
Weekly
■
Remove the fuel filter cap and clean the inside of the
fuel tank.
■
Remove or clean the filter at the bottom of the tank.
■
Remove and clean the spark plug (Figure 22), then adjust
the spark gap to 0.024 ~0.028 inch (0.6~0.7 mm). This
unit has electronic ignition, which requires no
adjustments.
Engine Oil
1. Drain the engine oil when the oil is
warm
as shown
in Figure 23.
2. Remove the oil drain bolt and sealing washer and
allow the oil to drain into a suitable container.
3. Replace engine oil with recommended type oil as
listed in Table 3. For engine oil capacity, see Table
2 (engine specifications). DO NOT overfill.
4. Install drain bolt with sealing washer and tighten
securely.
Used oil can generally be taken to your local recycling
center or service station for reclamation. Follow all required
environmental rules and regulations required in your area
concerning the disposal of hazardous waste such as used
oil and oil filters.
NOTE
0.028-0.031 IN.
(0.7-0.8 MM.)
GAP
Figure 22. Spark Plug Gap
Figure 23. Engine Oil (Draining)
Dispose of used oil properly.
DO NOT pour used oil on the
ground or down a drain.
NOTE
Heat should be used to break down
the loctite while you unthread the
head from the shaft. This will prevent
possible damage to the threads from
the loctite.
Whenever assembling, lubricating, or adjusting any part
of the gasoline vibrator make certain to stop the engine,
disconnect the spark plug wire and secure it away from
the spark plug.
WARNING - STOPPING ENGINE (MAINTENANCE)
Vibrating Head
■
Always inspect vibrating head for damage to threads
after every assembly. Replace housing and head
as necessary.
■
Measure vibrations per minute at the head to
determine if bearings in head require replacement.
Flexible Shaft
■
Remove, clean grease, the shaft core and bearings
every 100 hours. Use
Shell Durina EP2
or
equivalent grease. Wipe off old grease completely
and apply new grease to shaft evenly.
■
DO NOT allow water, dust or foreign debris to enter
the flexible hose while reassembling.
Maintenance Instructions
To receive trouble-free service from your MQ BP-25H CE
gasoline vibrator, follow these instructions, as well as the
instructions contained in the engine operating manual, flexible
shaft operations manual and the vibrator head operations
manual.
The flexible shafting requires cleaning and lubrication every
100 hours of operation. See flexible shaft maintenance
instructions shipped with shaft.
Vibrator heads should be inspected and relubricated every
100 hours of operation. See vibrator head maintenance
instructions shipped with vibrator head.