Filter
Top Products
PAGE 24 — BP-25H CE GASOLINE VIBRATOR — OPERATION MANUAL — REV. #4 (12/19/07)
Pivot Assembly (Frame)
Using a grease gun, apply a couple shots of lithium base
grease to the pivot bearing assembly as required.
Quick Disconnect Lock
A small amount of any lightweight oil should be used on the
locking mechanism (Figure 26) to help keep concrete from
sticking and also to lubricate the locking pin and spring.
Figure 26. Quick Disconnect Lock
V-Belt Tension
The V-belt (Figure 25) can be adjusted by loosening the
bearing block housing screws, and rotating the eccentric
end bell housing until the desired tension is achieved.
When the V-belt is properly tensioned, it should deflect
approximately 5 to 10 mm when 5-10 pounds of force is
applied centrally between the pulleys. Lock the
countershaft in place with the locking screw and wing
nut.
Engine Air Cleaner
1. Press the latch tabs on the top of the air cleaner cover
and remove the cover and foam filter element as shown
in Figure 24.
2. Clean foam element in warm, soapy water or nonflam-
mable solvent. Rinse and dry thoroughly. Dip the
element in clean engine oil and completely squeeze out
the excess oil from the element before installing.
Figure 25. V-Belt Tension
BP-25H CE GASOLINE VIBRATOR — MAINTENANCE
Figure 24. Engine Air Cleaner
LOCK PIN
ECCENTRIC
END BELL
OIL
DO NOT use gasoline as a cleaning solvent
to avoid creating the risk of fire or an
explosion.
DANGER - EXPLOSIVE FUEL HAZARD
3. Reinstall the filter and air cleaner cover.