Filter
Top Products
BP-25H CE GASOLINE VIBRATOR — OPERATION MANUAL— REV. #4 (12/19/07) — PAGE 25
BP-25H CE GAS VIBRATOR — PREPARATION FOR LONG -TERM STORAGE
For storage of the vibrator for over 30 days, the following is
required:
■
Drain the fuel tank completely, or add STA-BIL to the fuel.
■
Run the engine until the gasoline in the carburetor is
completely consumed.
■
Completely drain the oil from the crankcase and refill with
fresh oil.
■
Remove the spark plug, pour 2 or 3 cc of SAE 30 oil into the
cylinder and crank slowly to distribute the oil.
■
Slowly rotate the engine a few times with the starter rope and
install a new plug.
■
Pull out the starter rope slowly and stop at the compression
point.
■
Clean all external parts of the engine and frame with a soft
cloth.
■
Cover the unit and store in a clean, dry place.
Decommissioning Vibrator/Components
Decommissioning is a controlled process used to safely retire
a piece of equipment that is no longer serviceable. If the
equipment poses an unacceptable and unrepairable safety
risk due to wear or damage or is no longer cost effective to
maintain (beyond life-cycle reliability), and is to be
decommissioned (demolition and dismantlement), the
following procedure must take place:
■
Drain all fluids completely. These may include oil, gasoline,
hydraulic oil and antifreeze. Dispose of properly in accordance
with local and governmental regulations. Never pour on ground
or dump down drains or sewers.
■
Drain excess gasoline from the fuel system into an approved
storage container.
■
Engine block is made of recyclable aluminum. Plastic engine
components should be removed and recycled separately.
■
The frame and control arm are manufactured of recyclable
steel. Bring to a salvage yard or metal reclamation facility for
further dismantling.
■
The harness assembly is made of non-recyclable fabric.