Filter
Top Products
18
A Removing the Battery
To remove the battery, turn the camera off and open the
battery-chamber cover.
Press the battery latch in the
direction shown by the arrow to release the battery and then
remove the battery by hand.
A Formatting Memory Cards
If this is the first time the memory card will be used in the
camera or if the card has been formatted in another device,
select Format memory card in the setup menu and follow
the on-screen instructions to format the card (0 168).
Note
that this permanently deletes any data the card may contain.
Be sure to copy any photographs and other data you wish to
keep to a computer before proceeding.
D Memory Cards
• Memory cards may be hot after use.
Observe due caution when removing memory cards
from the camera.
• Turn the power off before inserting or removing memory cards.
Do not remove memory
cards from the camera, turn the camera off, or remove or disconnect the power source
during formatting or while data are being recorded, deleted, or copied to a computer.
Failure to observe these precautions could result in loss of data or in damage to the
camera or card.
• Do not touch the card terminals with your fingers or metal objects.
• Do not bend, drop, or subject to strong physical shocks.
• Do not apply force to the card casing.
Failure to observe this precaution could damage
the card.
• Do not expose to water, heat, high levels of humidity, or direct sunlight.
• Do not format memory cards in a computer.
A Removing Memory Cards
After confirming that the memory card access lamp is off,
turn the camera off, open the memory card slot cover, and
press the card in to eject it (q).
The card can then be
removed by hand (w).
A The Write Protect Switch
SD memory cards are equipped with a write protect switch to
prevent accidental loss of data.
When this switch is in the
“lock” position, the memory card can not be formatted and
photos can not be deleted or recorded (a beep will sound if
you attempt to release the shutter).
To unlock the memory
card, slide the switch to the “write” position.
8
GB
Write-protect switch
8
GB