Nikon COOLPIXP510BLK Digital Camera User Manual


 
E8
Reference Section
Using 3D Photography
The camera takes one picture for each eye to simulate a three-dimensional image
on a 3D-compatible TV or monitor.
1 Frame the subject.
The focus area that the camera focuses on can be
moved to areas other than the center of the frame. To
move the focus area, press the k button before taking
the first picture, and then rotate the multi selector or
press H, I, J, or K.
To adjust the following settings, press the k button to
temporarily cancel focus area selection, and then
adjust each setting.
– Focus mode (A (Autofocus) or p (macro close-up))
– Exposure compensation
2 Press the shutter-release button to take the first picture.
The focus, exposure and white balance are locked after the first shot,
and R is displayed on the monitor.
3 Move the camera horizontally to the right
until the translucent guide is aligned with
the subject.
To cancel shooting, press the k button.
4 Wait for the camera to automatically release the shutter.
The camera automatically takes the second picture when it detects that the subject is
aligned with the guide.
Shooting is canceled if the subject is not aligned with the guide within ten seconds.
Rotate the mode dial to y M d button M s 3D photography
6030
6030
6030
25m 0s
25m 0s
25m 0s
1/250
1/250
1/250 F5.6
F5.6
F3.0
Cancel
Cancel
Cancel