Filter
Top Products
CHECKING
BATTERY
POWER
Slide power switch
to
ON position, and confirm that a full
battery mark (
~
) appears on LCD panel, indicating
sufficient battery power, The battery mark and exposure
indications automatically tum off after 8 sec,
If
~
blinks: Batteries are nearing exhaustion, Have a fresh
set ready,
If
~
blinks: Batteries are just about exhausted, Slide power
switch
to
OFF and replace batteries with a fresh set.
If
no indication/mark appears, batteries are completely
exhausted or improperly installed, Replace,
When installing/replacing batteries, always read "NOTES
ON BATTERIES" on page
111,
About exposure meter
You can check battery power anytime by lightly pressing
shutter
re
lease button, This action activates the
exposure meter; LCD panel and viewfinder LCD show
aperture/shutter speed indications, and autofocus
operation starts (unless camera
is
set for manual
focusing), The exposure indications and battery mark
stay on for approx, 8 sec, after you take your finger off
shutter release button, then automatically tum off,
If you remove your finger from the button, these LCD
readouts
go
off approx, 2 sec, after the shutter
is
released without the flash, With the built-in flash or
accessory Speedlight activated, these LCD readouts
stay on for approx, 8 sec, after shutter release,
15