Filter
Top Products
2
Press
IN
button and
Ps
button
to
start film rewind. During
fi
lm rewind,
<:l
_ appears on LCD panel, and frame
counter counts backwards until rewind
is
complete.
• You can rewind film, before it reaches end
of
roll,
in
the same
manner .
•
If
film does not start rewind
or
if
fi
lm rewind has stopped at
mid-roll, check battery power.
If
battery power
is
insufficient,
tum power switch off, replace batteries with a fresh set, tum
power on, then press
IN
and
Ps
buttons again to restart film
rewind. (When replacing batteries, read "NOTES ON
BATIERI
ES"
on page 111.)
• Do not open camera back during film rewind. If camera back
is
opened, film rewind wi
ll
stop at mid-roll and
frr
and
<:l
_
blink
in
LCD panel; to restart
fi
lm rewind, press
IN
button and
Ps
button again.
3
After rewind automatically stops, confirm the frame
counter shows E and film installation symbol
<:l
blinks for a
few seconds.
Open camera back and remove film cartridge.
• To remove film, pull out the upper part of the cartridge then lift
up .
• With
an
exposed film cartridge left
in
the film cartridge
chamber, depressing shutter release button causes
<:l
to blink
in
LCD panel.
To conserve battery power, tum off power switch when
you are not using the camera. Always remove batteries
before storing the camera to prevent damage due to
leaking batteries.
25