Filter
Top Products
50
Features That Can Be Set Using the Multi Selector
Shooting Features
Using the Flash (Flash Modes)
The flash mode can be set to match the shooting conditions.
1 Press the multi selector H (m flash mode).
2 Press the multi selector H or I to choose the
desired flash mode and press the k button.
• See “Available Flash Modes” (A51) for more
information.
• If a setting is not applied by pressing the k button
within a few seconds, the selection will be canceled.
• When U (Auto) is applied, D is only displayed for
a few seconds, regardless of Photo info settings
(E53).
3 Frame the subject and take a picture.
• The flash lamp indicates flash status when the shutter-
release button is pressed halfway.
- On: The flash will fire when you press the shutter-
release button all the way down.
- Flashes: Flash charging. Wait a few seconds and try
again.
- Off: Flash will not fire when picture is taken.
• If the battery is low, the monitor will turn off, and remain off, while the flash charges.
C Effective Range of the Flash
When ISO sensitivity is set to Auto, the flash has a range of 0.5–4.5 m (1 ft 8 in.–14 ft) at the
maximum wide-angle zoom position and a range of 0.5–2.2 m (1 ft 8 in.–7 ft 2 in.) at the maximum
telephoto zoom position.
Auto
11 00
29m 0s