Filter
Top Products
If the camera fails to function as expected, check the list of common problems
below before consulting your retailer or Nikon-authorized service representative.
Display, Settings, and Power Supply
Problem Cause/Solution
Confirm all connections. 16
Off is selected for Charge by computer in the 187
setup menu.
When charging by connecting the camera to a 162
computer, battery charging stops when the camera
is turned off.
The battery inserted in
When charging by connecting the camera to a 162
the camera cannot be
computer, battery charging stops when the
charged, computer is suspended (sleeping), and the camera
may turn off.
Depending upon computer specifications, settings,
and status, charging the battery inserted in the
camera may not be possible via computer
connection.
• Battery isexhausted. 24
Camera cannot be
The camera cannot be turned on while connected to 16
turned on.
an electrical outlet via the Charging AC Adapter.
• Battery isexhausted. 24
Camera has turned off automatically to save power. 184
The camera and battery may not perform properly if 195
they are cold.
The camera turns off if the Charging AC Adapter is 16
Camera turns off without connected while the camera is on.
warning. The camera turns off ifthe USBcable connecting it to 158,
a computer or printer is disconnected. Reconnect 160,
the USB cable. 164
Inside of the camera has become hot. Leave the
camera off until the inside of the camera has cooled,
and then try turning it on again.
• Camera isoff.
Standby mode for saving power: press the power 4, 10,
switch, shutter-release button, [] button, or • (_1_ 19, 30
Monitor is blank, movie-record) button, or rotate the mode dial.
When flash lamp blinks, wait until flash hascharged. 34
Camera and computer are connected via USBcable. 158
Camera and TVare connected via A/V cable or HDMI 155
cable.
• Adjust monitor brightness. 175
Monitor is hard to read. • Monitor isdirty. Clean monitor 196
2-
ff
8
o_
205