Filter
Top Products
Problem
Date and time of
recording are not correct.
No indicators displayed
in monitor.
Print date not available.
Date not imprinted on
images even when Print
date is enabled.
Screen for setting time
zone and date is
displayed when camera
is turned on.
Camera settings reset.
n
_" Monitor turns off, and
_- the power-on lamp
oZ blinks rapidly.
o_
__ Camera becomes hot.
206
• If camera clock has not been set, "Date not set"
indicator blinks with shooting and movie recording.
Images and movies saved before clock is set are
dated %0/00/0000 00:00" or "01/01/2011 00:00"
respectively. Set the correct time and date from tile
Time zone and date option in tile setup menu.
Check camera clock regularly against more accurate
timepieces and reset as required.
Hide info is selected for Photo info.
Select Show info.
Camera clock hasnot been set.
Cause/Solution
20,
172
The current shooting mode is one that does not
support Print date.
Tile date cannot be imprinted on movies.
The date cannot be imprinted on still images saved
during movie recording.
Clock battery isexhausted; all settings were restored to
their default values.
Battery temperature ishigh. Turn off camera and allow
battery to cool down before resuming use. After the
lamp blinks for three minutes, the camera will turn off
automatically. Pressing the power switch also turns off
the camera.
The camera may become hot when shooting movies
for an extended period of time or when the camera is
172
]75
20,
172
177
20,
173
19
Electronically Controlled Cameras
In extremely rareinstances, unusual characters mayappear in tile monitor and tile
camera may stop functioning. In most cases, this phenomenon is caused by a
strong external static:charge. Turn the camera off, remove and replace the battery,
then turn the camera on again. In the event of continued malfunction, contact
your retailer or Nikon-authorized service representative. Note that disconnecting
the power source asdescribed above may result in the loss of any data not saved
to internal memory or the memory card at the time the problem occurred. Data
already saved will not be affected.