Filter
Top Products
11
En
Getting started
Inserting/Removing a card
“Card” in this manual refers to the xD-Picture Card. The camera uses the
card to record pictures.
●Inserting a card
1 Make sure that:
• The lens barrier is closed.
• The monitor is off.
• The lamps on the right of the viewfinder are off.
2 Open the card cover.
3 Face the card the correct way and insert it into the card slot as
shown.
• Insert the card while keeping it straight.
• When the card is inserted fully, you will feel it lock into place.
• Inserting the card the wrong
way or at an angle could
damage the contact area or
cause the card to jam.
• If the card is not inserted all
the way, data may not be
written to the card.
4 Close the card cover.
Notch
Index area side
When the card is inserted properly.
●Removing the card
1 Make sure that:
• The lens barrier is closed.
• The monitor is off.
• The lamps on the right of the viewfinder are off.
2 Open the card cover.
3 Push the card all the way in to unlock it, then let it return slowly.
• The card is ejected a short way and then stops.
4 Hold the card straight and pull it out.
5 Close the card cover.
Card cover
1 D395/C160_B-E1 2004.1.30 5:53 PM Page 11 (1,1)