Filter
Top Products
1918
How to attach
1. Place the light-emitting section in the standard position
(horizontal, front). If it is in the locked position, press and
turn the Bounce lock release button.
2. Remove the hot shoe cover from the camera.
• Store the hot shoe cover in the pocket located on the inner
side of the flash case.
3. Loosen the lock ring.
•
If the lock pin is in the out position, press it in by turning it all
the way in the opposite direction to [ LOCK] until it stops.
• Do not apply excessive force to the lock pin.
• Do not touch the electric contact with a finger or metallic object.
• Do not attach the electronic flash while the lock pin is in the out position.
Otherwise, malfunction may result.
4. Slide the electronic flash all the way into the hot shoe until
it stops with a click.
5. Tu rn the lock ring all the way into the direction of [ LOCK]
until it stops.
AT TACHING TO THE CAMERA/REMOVING FROM THE CAMERA
Confirm that both the camera and electronic flash are off.
Attaching or removing the electronic flash while either the flash or the camera is on may result in malfunction.
How to remove
1.
Loosen the lock ring completely, then slide the electronic
flash out of the hot shoe.
2. Attach the hot shoe cover to the camera.
Notes
To use the electronic flash with a digital camera not equipped with hot shoe:
• If the camera has an external flash terminal, the electronic flash can be attached and connected using the flash
bracket and bracket cable (optional).
• The electronic flash cannot be used with a camera that is not equipped with a hot shoe or external flash terminal.
Lock pin
Electric contact