Filter
Top Products
3130
Selected
adjustment value
Adjustment value
displayed on FL-36
Actual light intensity
adjustment
FL-36 +0.3
+0.3 +0.6
Camera +0.3
The light intensity adjustment must be set to ON in the
custom setup operation (page 47).
• The indicator appears in the control panel.
1.
Tu rn the select dial to choose a light intensity adjustment value.
0 +0.3 +0.7 +1.0 ...+3.0
0 –0.3 –0.7 –1.0 ... –3.0
2. The display shows the light intensity adjustment value ex-
cept when the value is 0. In this case, the displayed light
control range corresponds to an adjustment value of 0.
3. If the camera’s flash adjustment mode is selected, the
actual flash light intensity will be the total of the light
intensity adjustment value set on the FL-36 and that
set on the camera. The light intensity adjustment value
displayed is that of the FL-36 only.
[Example]
Light intensity adjustment value
Light intensity adjustment
The flash light intensity can be adjusted between +3 and –3.
FP TTL AUTO indicator
ZOOM indicator
Displayed according to the
focal length of the lens.
1. The control panel shows the light control range according
to the camera setup.
2. Confirm that the distance to the subject is within the light
control range.
If not, adjust the lens iris (F) or the subject distance.
The light control range varies according to the camera
setup (ISO speed, lens iris (F) and lens focal distance
(ZOOM). The light control range is smaller than that in the
TTL mode.
3. When flash activation has been performed correctly, the
AUTO CHECK lamp blinks for about 5 seconds after the
shutter is released.
Light control range