Filter
Top Products
E-22
: •
Seal the Case by turning both buckle lock levers down in
arrow direction. When one of the buckles is left open, the
Case will not be sealed and water leakage will be caused.
CAUTION
Seal the Case.
When the rear lid is closed
(quietly, so that the O-ring
will not come out of the
groove), the buckles are
engaged with the edge of
the rear lid, and the buckle
lock levers are pushed down
in arrow direction, the Case
will be sealed airtight.
Check the loading status.
Always perform the following final checks before sealing the Case.
ț
Has the camera been inserted properly so that the zoom lever works?
ț
Has the silica gel bag been placed in the correct position and in the proper
way?
ț
Are both the O-rings and the contact surfaces of the front lid free of dirt and
other foreign matter?
ț
Are the O-rings correctly positioned in the groove of the front and rear lids?
ț
Is the lens port attached properly and are the buckles locked correctly?
ț
the TTL cable connector cap attached tightly?
Install the special balance weight.
Install the special balance weight
to the tripod mounting thread at
the bottom of the Case. Install the
balance weight securely by
tightening the accessory screw of
the balance weight.