Filter
Top Products
E-23
After sealing the case, perform the following final checks to confirm
proper operation of the camera.
ț Confirm that the camera can be turned ON/OFF from the case’s
power switch lever.
ț Confirm that the camera mode can be switched with the case’s
mode dial knob.
ț Press the Case’s shutter level and see if the camera shutter can be
released accordingly.
ț Press other buttons on the Case to see if the camera functions
accordingly.
Perform the final checks after loading.
:•If the camera does not function properly, restart the digital
camera installation procedure from “Check the digital
camera.” on page E-19 of this manual.
•Make sure that the mode dial can be moved after the
camera has been loaded in the Case. If the mode dial
does not move, there may be oil or grease on it; wipe it
clean.
•
When the digital camera is not used for about 3 minutes
while in the shooting mode, it enters the sleep mode
(standby status) and no operations are possible. To cancel
sleep mode and return to operation status, press the zoom
lever, shutter button or any other button. For details, refer to
the digital camera's instruction manual.
CAUTION