Filter
Top Products
58
EN
Getting to know your camera better
When you get an error message on the camera...
Monitor indication Possible cause Corrective action
q
CARD ERROR
There is a problem with the
card.
This card cannot be used. Insert a new card.
q
WRITE PROTECT
Writing to the card is
prohibited.
The recorded image has been protected (read-
only) on a computer. Download the image to a
computer and cancel the read-only setting.
>
MEMORY FULL
The internal memory has no
available memory and
cannot store any new data.
Insert a card or erase unwanted data.
Before erasing, back up the data of
important pictures using the card, or
download such pictures to a computer.
q
CARD FULL
The card has no available
memory and cannot store
any new data.
Replace the card or erase unwanted data.
Before erasing, download important
pictures to a computer.
L
NO PICTURE
There are no pictures in the
internal memory or on the
card.
The internal memory or the card contains no
pictures.
Record pictures.
r
PICTURE ERROR
There is a problem with the
selected picture and it cannot
be played back on this
camera.
Use image processing software to view the
picture on a computer. If that cannot be
done, the image file is damaged.
r
THE IMAGE
CANNOT BE
EDITED
Pictures taken by other
cameras, taken in [D] or
previously edited or
corrected pictures cannot be
edited or fixed.
Use image processing software to edit the
pictures.
CARD-COVER
OPEN
The battery/card
compartment cover is open.
Close the battery/card compartment cover.
g
BATTERY EMPTY
The battery is empty. Charge the battery.
The card was not read. Or,
the card is not formatted.
• Select [CLEAN CARD] and press o.
Remove the card and wipe the contact
area with a soft, dry cloth.
• Select [FORMAT] [YES] and press o.
All data on the card is erased.
There is an error in the
internal memory.
Select [MEMORY FORMAT] [YES] and
press o. All data in the internal memory is
erased.
OK
SET
CARD SETUP
CLEAN CARD
FORMAT
IN
OK
SET
MEMORY SETUP
POWER OFF
MEMORY FORMAT
d4354_e_0000_7.book Page 58 Thursday, December 20, 2007 10:25 AM