Filter
Top Products
User’s Manual
BX-AL133
For more information, please visit our website at:
http://www.OptomaUSA.com
User’s Manual | 9
3. Attaching the lens to the bracket
Attach the Optoma BX-AL133 anamorphic lens to the bracket using the plastic knobs
supplied with the lens. Adjust the anamorphic lens vertically for correct alignment. When
the image is correct, tighten the knobs against the bracket. Using the remote, test run
LENS IN and LENS OUT commands.
4. Configuring the lens speed
The lens has two operating speed modes – FAST and SLOW. Slow is the default from
the factory. The slow mode reduces the inertia exerted by the lens on the mounting
system by accelerating and decelerating very slowly, and by limiting the top speed of the
lens as it traverses the sled.
If the sled is on a very rigid mount that is not
subject to any sway, you can speed up the
traversal speed by setting the lens speed to FAST.
If you notice any swaying in the mounting, reset
the speed to SLOW.
Some users set the speed to SLOW when used in
conjunction with screen masking systems. Your
speed setting will be “remembered” by the control
unit even if the power is interrupted.
Congratulations, you are now ready to experience
widescreen cinema from your home theater.
Tighten Knobs
OFF
LENS OUT
PANEL OFF
SLOW
ON
LENS IN
PANEL ON
FAST