Filter
Top Products
44
Setting menus
The underlining indicates the factory setting.
Item/
(display mode)
Description of settings
REC TIME
(Camera)
For setting the recording duration for which
intermittent recording is to be performed.
0.5s
:
0.5 sec.
1s :
1.0 sec.
1.5s :
1.5 sec.
2s :
2.0 sec.
INTERVAL TIME
(Camera)
For setting the duration of the interval time
with which intermittent recording is to be
performed.
30s :
30 sec.
1m :
1 min.
5m :
5 min.
10m :
10 min.
AV IN/OUT SETUP screen
Item/
(display mode)
Description of settings
A DUB INPUT
(VCR)
For selecting the sound which is to be
recorded when audio dubbing is performed.
MIC:
The sound from the internal microphone
or the sound from the external
components connected to the INPUT 1
and 2 connectors is recorded. (The
sound is selected using the CH1 SELECT
switch and CH2 SELECT switch.)
A_IN:
The sound of the audio component
connected to the AUDIO IN/OUT
connectors (pin jacks) is recorded.
<Note>
If audio dubbing is performed when the
sound has been recorded in the 16-bit
audio mode, the sound will be recorded
over the sound heard during shooting.
DV OUT
(VCR)
For setting the function, which converts the
analog signals which have been input into
digital signals and outputs them from the
DV connector, to ON or OFF.
OFF ON
INTERVAL REC
(Camera)
For setting the intermittent recording mode.
OFF
:
Intermittent recording is not performed.
ON:
When the START/STOP button is
pressed, intermittent recording is
performed with the cycle set by the REC
TIME item and INTERVAL TIME item.
ONE-SHOT:
The time lapse shooting mode is
established.
When the START/STOP button is
pressed, recording is performed for the
number of seconds set by the REC TIME
item, after which the recording pause
mode is established.
O
When intermittent recording is set to ON or
ONE-SHOT, “I –” flashes on the left of the
VCR operation mode. When recording is
started, it stops flashing and lights.
O Even when intermittent recording is set to
ON or ONE-SHOT, the intermittent
recording mode returns to OFF when the
power is turned off.
OWhen the progressive mode has been
set to 24P or 24P (ADV), the OFF is
established regardless of this item’s
setting.
UB PRESET
(Camera)
(VCR)
For setting the user’s bit. However, USER
must be selected for the UB MODE item
setting.
UB MODE
(Camera)
(VCR)
For setting what is to be recorded as the
user’s bit.
USER:
The user’s information is recorded.
TIME:
The time of the recording is recorded.
DATE:
The date of the recording is recorded.
TCG:
The time code generator’s value is
recorded.
FRM. RATE:
The frame rate information for frame
conversion is recorded.
RECORDING SETUP screen
Item/
(display mode)
Description of settings
22 02 22 22
Recording control
information
OUpdated frame information
OREC START/STOP
information
Frame rate information
OFrame rate (60, 30 or 24)
OI/P identification information
OConversion information
OFrame rate coefficient
Frame sequence number
OA number from 0 to 4 is displayed
in the 24P or 24P (ADV) mode.
O“F” is displayed in the 60 or 30P
mode.
User’s bit value verification
information