Filter
Top Products
E-20
ENGLISH
Basic operation (Continued)
<Notes>
z If a scene file is loaded while the volume
operation mode is set to the absolute value
mode, and then the VR ACTIVE button is
operated, the set value will correspond to
the volume angle and the loaded value will
be lost.
If you want to operate the volume from the
value loaded in the scene file, operate the
unit while the VR ACTIVE button lamp is
flashing or the operation modes of the
volumes for WHITE and BLACK are set to
the relative value mode before operating
the VR ACTIVE button.
z When a scene file is stored or loaded, the
button lamps for the file numbers of the files
stored or loaded and the LOAD button is
turned on. Press the LOAD button to turn
the button lamp off. When the camera
menu is opened or the scene file data is
loaded from the SD memory card, the
lamps for both of the File No. button and
the LOAD button turn off.
z When the camera menu is open,
operations of the scene file are disabled.
2) Items stored in the scene file
Refer to the Menu item Files for storing are
checked with a “Yes” Since the same operation
applies to storing on the SD memory card, when
a scene file stored in a specific unit of the remote
controller is used for another unit of the remote
controller, load data from the scene file from the
specific unit and store on an SD memory card,
and then read them out from the card and store
them in the scene file of the other unit.
<Note>
Do not turn off the power when a scene file is
being stored. Otherwise, data in the scene file
may be corupted.
<Reference>
It is possible to adjust the scene file setting of the
unit to the same state as the factory setting for
the camera recorder using the following
procedure.
However, the settings that cannot be set with the
unit cannot be set to the same state.
1 Set the settings for the camera recorder to
the factory settings. For details, refer to the
operation manual of the camera recorder.
2 Connect the unit to the camera recorder.
Settings for the unit will be imported from the
camera recorder.
3 Execute RCU-FACTORY on the SYSTEM
menu of the unit.
4 Store the settings on the unit to scene files 1
to 5 of the unit or an SD memory card.
Operation for recording
If the RECORDER ENABLE button is pressed to
switch to the recorder mode, operations of the
camera recorder are enabled.
If the REC INH button lamp is on, the REC S/S
button on the unit will be inhibited. To start and
stop recording, turn off the lamp of the REC INH
button by pressing the button, and start and stop
recording using the REC S/S button.
<Notes>
z While the REC INH button lamp is on, REC S/
S button operations are inhibited.
z If the RECORDER ENABLE button lamp turns
off by pressing the button while the recording
part is operated, the state of the recording
before turning off the lamp is retained and it is
possible to operate the scene file built into the
unit.
z It is possible to set whether the value adjusted
on the unit is retained on the camera recorder
or not, by using RC-DATA-SAVE in the FUNC
menu of the unit.
AJ-RC10G(VQT1A65-1).book 20 ページ ２００７年２月１４日 水曜日 午後４時１６分