Filter
Top Products
E-22
ENGLISH
Saving/Loading of scene files onto the SD memory card
(Continued)
To write data on the card
1 Select “SYSTEM” using the SHUTTER/
SYSTEM button, and display the menu on
the second layer using the
4
button.
2 When the indication “CARD-WR” is
displayed on the LCD panel together with the
file number displayed under the indication,
turn the Rotary Encoder 1 to select the file.
<Note>
If the file already exists, the title is displayed
under the TITLE indication. Be careful and
do not overwrite the file.
3 When the cursor for entering the title is
displayed on the LCD panel, turn the Rotary
Encoder 3 to select the letters and turn the
Rotary Encoder 2 to move the cursor.
Up to eight letters can be entered. Once the
eighth letter is entered, the last letter will
flash.
4 When the Rotary Encoder 3 is pressed, the
indication “NO?” is displayed on the LCD
panel. Turn the Rotary Encoder to select the
indication “YES?” and start writing data by
pressing the Rotary Encoder 3 again.
5 When the writing operation starts, the SD
card access lamp is on and the indication
“ACTIVE” is displayed on the LCD panel.
6 When the writing of the data is finished, the
SD memory card access lamp turns off, and
the indication “OK” is displayed on the LCD
panel.
To delete files from the card
1 Select “SYSTEM” using the SHUTTER/
SYSTEM button, and display the menu on
the third layer using the
4
button.
2 When the indication “CARD-DEL” is
displayed on the LCD panel together with the
file number displayed under the indication,
turn the Rotary Encoder 1 to select the file to
be deleted.
3 When the Rotary Encoder 3 is pressed, the
indication “NO?” is displayed on the LCD
panel. Turn the Rotary Encoder 3 to select
the indication “YES?” and start deleting data
by pressing the Rotary Encoder 3 again.
4 When the deleting operation starts, the SD
card access lamp is on, and the indication
“ACTIVE” is displayed on the LCD panel.
5 When the deletion of the data is finished, the
SD memory card access lamp turns off, and
the indication “OK” is displayed on the LCD
panel.
Initialization of the card
1 Select “SYSTEM” using the SHUTTER/
SYSTEM button, and display the menu on
the fourth layer using the
4
button.
The indication “EXEC” is displayed.
2 When the Rotary Encoder 3 is pressed, the
indication “NO?” is displayed on the LCD
panel. Turn the Rotary Encoder 3 to select
the indication “YES?” and start the
initialization by pressing the Rotary Encoder
3 again.
The following procedures are the same as
procedures
4 and 5 for deleting files from the
card.
AJ-RC10G(VQT1A65-1).book 22 ページ ２００７年２月１４日 水曜日 午後４時１６分