Filter
Top Products
–68–
Adjustments and Setup During Recording
Setting the Gain Selector Value
When shooting in locations without sufficient brightness, bright images can be obtained by raising
the gain. However, care should be taken as raising the gain also increases the noise.
The gain value for the image amplifier is selected by the GAIN switch. The gain values corre-
sponding to the L, M and H positions of the GAIN switch are set at the MASTER GAIN page of the
setting menu.
Setting the gain selector value
1 Set the MENU SET/OFF switch to the SET position while the SHIFT/ITEM button and UP
button are held down together.
2 Press the PAGE button to display the MAIN menu screen 1 of 4.
3 Press the SHIFT/ITEM button to move the cursor to the position of the setting page on which
the gain is to be set.
4 Press the UP or DOWN button to open the setting page.
5 Press the SHIFT/ITEM button to move the cursor to the “MASTER GAIN” position.
6 Press the UP or DOWN button to set the gain value.
Any gain value can be set regardless of whether it is high or low from among the p3, 0, 3, 6,
9, 12, 15, 18, 21, 24 and 30 dB setting options.
To reset the gain values to their factory settings (LOWr0dB, MIDr9dB, HIGHr18dB), select
READ FACTORY DATA on the “INITIALIZE” SUB menu page on MAIN menu screen 4 of 4,
and press the UP or DOWN button.
7 When the menu operations are completed, set the MENU SET/OFF switch to the OFF po-
sition.
The setting menu is cleared from the viewfinder screen, and the unit’s current statuses ap-
pear at the top and bottom of the viewfinder screen.
¢
|
LOW SETT ING
{
MASTER
MASTER
GA I N
:
:
:
:
:
:
:
:
:
:
0dB
H.DTL
H.DTL
DTL
LEVEL
LEVEL
.DTL
DTL
LEVEL
10
V10
CORING 03
FREQ . 03
DARK 00
DEPEND. 00
GAMMA 0.45
BLACK STRETCH OFF
TABLE AM
»
»
»
ATRI X