Filter
Top Products
– 150 –
Warning System
Item
TAPE END
BATTERY
END
No display
Display window (LCD)
Warning
contents
Warning
display
The tape is
nearing its
end.
The tape has
reached its
end.
The battery
has almost run
out.
The battery
has run out.
Memory status
error between
SYSCON and
DV.
Warning
display
status
Remain-
ing
battery
level
display
Remain-
ing tape
length
display
WARN-
ING
lamp
REC
lamp
Lamps
Emitted
4 times
per
second
Continu-
ous
tone
Emitted
4 times
per
secondF1)
Continu-
ous
tone
Emitted
4 times
per
second
F1)
Warning
tone
VTR (section)
operation
Operation
continues.
Recording,
playback or fast
forward operation
stops.
Operation
continues.
Operation stops.
Error code
[00:00:00:11] will
be displayed for
5 seconds in the
time code display
position in the
status display
window.
However, the
main unit will be
put into Enforced
Recording mode
and recording will
continue.
Countermeasures
Replace the tape
as necessary.
Replace the
cassette or rewind
the tape.
Replace the
battery as
necessary.
Replace the
battery.
Switch the power
OFF and consult
your local dealer.
E TAPE
F
E BATT
F
No
display
Flashes
F1)
Flashes
Flashes
Flashes
Flashes
1 time
per
secondF1)
Lighted
Flashes
1 time
per
second
Lighted
Flashes
4 times
per
second
for
3 se-
conds
Flashes
1 time
per
second
Flashes
4 times
per
second
Flashes
1 time
per
second
Flashes
1 time
per
secondF3)
Flashes
4 times
per
second
for
3 se-
conds
1 of the
7 bars
displayed;
5-0
display
inside
the
viewfinder
flashes
All 7 bars
displayed
1 of the
7 bars
displayed
All 7 bars
displayed
F1) During recording
F2) During playback, fast forward or rewind
F3) During recording, the REC and BATT lamps flash in alternation.
When recording is paused (REC/PAUSE), the REC and BATT lamps flash together.
|Notes{
ÁWhen trouble occurs with the external VTR connected to the unit, warnings are displayed only by the unit’s REC and TALLY
lamps.
ÁWhen connecting the external VTR to the 26-pin/12-pin output adaptor and recording simultaneously with the internal and
external VTRs, the REC and TALLY lamps flash if trouble occurs in either VTR. Check the warning displays of each VTR to
confirm the error contents.
Warning system priorities are as follows.
1 SLACK
2 BATTERY END
3 TAPE END
4 HUMID
5 SERVO
6RF
7 BATTERY NEAR END
8 TAPE NEAR END