Filter
Top Products
17
Shooting (recording)/playback function section (4)
;MONITOR OUT switch
This is used to select the video and audio signals
which are to be output from the HD SDI MON
connector and the audio signals which are to be
output from the AUDIO OUT connectors.
EE/PB
: During playback, the playback video and
playback audio signals are output; in all
other modes, the EE video and EE audio
signals are output.
EE
: The EE video and EE audio signals are
output at all times.
<Note>
It should be borne in mind that some products may
not be able to process properly the audio signals
which are output from the HD SDI EE connector
and the HD SDI MON connector at this 60.00 Hz
frequency setting.
For details, consult your dealer.
<CHARACTER switch
This controls whether the characters are to be
superimposed onto the pictures which are output
from the HD SDI MON connector.
ON
: The characters are superimposed.
OFF
: The characters are not superimposed.
=VTR START button
When this is pressed, recording starts; when it is
pressed again, recording stops.
This button functions in the same way as the lens
VTR button.
>VTR SAVE/STBY (tape protection) switch
This is used to switch the VTR operation status
while the REC PAUSE mode is established for the
VTR recording.
SAVE
: This is the tape protection mode. The
cylinder is stopped in the half-loading status.
Less power is consumed than at the STBY
position, and the operating time provided by
the battery is prolonged. Compared with the
STBY position, it takes longer for recording to
commence after the VTR START button =
has been pressed.
When the switch is set to this position, the
VTR SAVE lamp inside the viewfinder lights.
STBY
: At this position, recording is commenced as
soon as the VTR START button is pressed.
<Note>
When the prescribed amount of time has elapsed in
the STBY mode, the unit is automatically sets the
switch to the SAVE status in order to protect the
tape. To return the unit to the STBY mode, set the
VTR SAVE/STBY switch to SAVE, and then again
to the STBY position.
Parts and their functions (continued)
> <
=
;