Filter
Top Products
65
Setting the time data
When the user bits and time code are both to be used,
the user bits are set first.
If the time code is set first, the time code generator
will stop while the user bits are being set so that the
time code setting will be off.
The time code setting range extends from 00:00:00:00
to 23:59:59:29.
In the internal color bar signal recording mode,
memos (dates and times) of up to six hexadecimal
digits can be recorded on the sub-code track by
setting the user bits.
User bits memory function
The user bits settings (except for the actual time) are
automatically saved in the memory and retained even
after the power is turned off.
<Notes>
OIn the camera image recording mode, the tape
management information shown on page 68 is
output.
OWhen DATE is selected from the UB MODE items,
the real time operations for year/month/day of the
TIME/DATE screen are adhered to.
OWhen TIME is selected from the UB MODE items,
the real time operations for hours/minutes/seconds
of the TIME/DATE screen are adhered to.
OThe user bits setting contents are output to the six
higher digits of the user bits in the VIDEO AUX area
(which used to be the VITC area). In the internal
color bar signal recording mode, they are also
output to the six higher digits of the LTC user bits.
OThe user bits cannot be set since the active frame
information and other tape management
information is always output to the two lower digits
of the user bits.
Setting the user bits
2
Set the DISPLAY switch to UB.
3
Set the TCG switch to SET.
6
Select UB MODE item on the TC/UB screen of
VTR MENU.
4
Set the user bits using the SHIFT button, “+” button
and “–” button.
SHIFT button:
This is used to start the digit to be set flashing.
Each time it is pressed, the flashing moves by
one digit to the right.
“+” button:
This increments by 1 the numerical value of the
flashing digit.
“–” button:
This decrements by 1 the numerical value of the
flashing digit.
5
Set the TCG switch to F-RUN or R-RUN.
Hexadecimal
notation
Display
ABCDEF
A to F in hexadecimal notation are displayed as follows:
2
4
1
3,5
1
Set the OUTPUT (output signal selector)/AUTO
KNEE switch to BARS.