VQT1Q36
114
Others
[PLEASE TURN CAMERA OFF AND THEN ON AGAIN]
•
This message appears when the camera is not operating properly.
> Turn the camera off and on. If the message persists, contact the dealer or your nearest
Service Center.
[MEMORY CARD PARAMETER ERROR]
> Use a card compatible with this unit. (P17)
• You can only use an SDHC Memory Card if using cards with 4 GB or more capacity.
[MEMORY CARD ERROR PLEASE CHECK THE CARD]
•
An error has occurred accessing the card.
> Insert the card again.
[READ ERROR PLEASE CHECK THE CARD]
•
An error has occurred reading the data.
> Insert the card again.
[WRITE ERROR PLEASE CHECK THE CARD]
•
An error has occurred writing the data.
> Turn the camera off and remove the card. Insert the card again and turn the camera on.
Make sure the camera is turned off before removing or inserting the card to avoid damage.
[MOTION RECORDING WAS CANCELLED DUE TO THE LIMITATION OF THE
WRITING SPEED OF THE CARD]
•
When you set the picture quality to [÷], [ý], [ü] or [ÿ], we recommend using a
high-speed card with “10MB/s” or greater displayed on the package.
• Depending on the type of SD Memory Card or SDHC Memory Card, motion picture recording
may stop in the middle.
[A FOLDER CANNOT BE CREATED]
•
A folder cannot be created because there are no remaining folder numbers that can be used.
(P101)
> Format the card after saving necessary data on a PC etc. (P26) If you execute
[NO.RESET] in the [SETUP] menu after formatting, the folder number is reset to 100.
(P25)
[PICTURE IS DISPLAYED FOR 4:3 TV]/[PICTURE IS DISPLAYED FOR 16:9 TV]
•
The AV cable is connected to the camera.
> Press [MENU/SET] if you want to delete this message at once.
> Select [TV ASPECT] in the [SETUP] menu if you want to change the TV aspect. (P26)
• This message also appears when the USB connection cable is connected to the camera only.
In this case, connect the other end of the USB connection cable to a PC or a printer. (P100,
102)
[PRINTER BUSY]/[PLEASE CHECK THE PRINTER]
•
The printer cannot print.
> Check the printer.
DMC-FX500P_mst.book 114 ページ 2008年2月25日 月曜日 午後5時54分