Filter
Top Products
97
VQT1Q36
Advanced (Playback)
Note
•
The number of prints can be set from 0 to 999.
• With a printer supporting PictBridge, the date print settings of the printer may take precedence
so check if this is the case.
• It may not be possible to use the DPOF print settings with other equipment. In this case, cancel
all the settings, and reset the settings.
• If the file is not based on the DCF standard, the DPOF print setting cannot be set.
You can set protection for pictures you do not want to be deleted by mistake.
Select [PROTECT] on the [PLAYBACK] mode menu. (P21)
Press [‚] to return to the menu screen.
• Press [MENU/SET] to close the menu.
∫ Canceling all the [PROTECT] settings
1 Select [CANCEL] on the screen shown in step 2 and then press [MENU/SET].
2 Move 3 to select [YES] and then press [MENU/SET].
3 Press [MENU/SET] to close the menu.
•
If you press [MENU/SET] while canceling protection, the canceling will stop halfway.
Note
•
The protect setting may not be effective on other equipment.
• Even if you protect pictures in the built-in memory or a card, they will be deleted if the built-in
memory or the card is formatted.
• Even if you do not protect pictures on an SD Memory Card or an SDHC Memory Card, they
cannot be deleted when the card’s Write-Protect switch is set to [LOCK].
P [PROTECT]
Move 3/4 to select [SINGLE] or [MULTI] and then
press [MENU/SET].
Select the picture, and then press
[MENU/SET].
When [MULTI] has been selected
•
Repeat these steps for each picture.
• The settings are canceled when [MENU/
SET] is pressed again.
[SINGLE] [MULTI]
Move 2/1 to select
the picture.
Move 3/4/2/1 to
select the pictures.
1
2
3
4
DMC-FX500P_mst.book 97 ページ ２００８年２月２５日 月曜日 午後５時５４分