Filter
Top Products
Connecting to other equipment
85
VQT1C39
Connecting to other equipment
Connecting to a PC
You can acquire recorded pictures to a PC
by connecting the camera and the PC.
The software [LUMIX Simple Viewer] or
[PHOTOfunSTUDIO-viewer-]
(for Windows
®
) in the CD-ROM (supplied)
allows you to easily acquire pictures
recorded with the camera to a PC, print
them and send them by e-mail.
If you use “Windows
98/98SE”, install
the USB driver and then connect it to
the computer.
For information about the software in the
CD-ROM (supplied) and installing this
software, refer to the separate operating
instructions for PC connection.
A: USB connection cable (supplied)
B: AC adaptor (DMW-AC6PP; optional)
• Use batteries with sufficient battery power
(P23) or the AC adaptor (DMW-AC6PP;
optional).
• Turn the camera off before inserting or
removing the cable for the AC adaptor
(DMW-AC6PP; optional).
• Set the camera to a mode other than [ ]
mode.
1 Turn on the camera and the PC.
2 Connect the camera to a PC via
the USB connection cable A
(supplied).
• Connect the USB connection cable with
the [ ] mark facing the [1] mark on
the [DIGITAL] socket.
• Hold the USB connection cable at C
and insert straight in or take straight
out. (If you forcibly insert the USB
connection cable at a slant or upside
down you can deform the connection
terminals and damage the camera or
the connected equipment.)
D: This message appears during data
transfer.
[Windows]
The drive appears in the [My Computer]
folder.
• If you are connecting the camera to a PC
for the first time, the required driver is
installed automatically so that the camera
can be recognized by “Windows Plug and
Play”. The drive then appears on the
[My Computer] folder.
[Macintosh]
The drive is displayed on the screen.
• The drive is displayed as [LUMIX] when
you connect the camera with no card
inserted.
• The drive is displayed as [NO_NAME] or
[Untitled] when you connect the camera
with a card inserted.
ACCESS
VQT1C39ENG.book 85 ページ ２００６年１２月２１日 木曜日 午前１０時５７分